Heating Pads

The universal heating pad is a new kind of preheater. It is a thin, flexible heating pad that provides even, gentle heating to engine oil, hydraulic fluid, transmission oil, water, etc. Heat from Universal conducts quickly through the metal body of a fluid vessel to provide a wide heating area and rapidly heat the fluid supply without burning it. This heating pad mounts to the outside of an oil pan (or storage tank, reservoir...) And it has no coils to clog or fail.

The heating pad warms and holds engine oil at summer-like (LWD) or near engine operating temperatures (HWD) for easier starting and instant oil pressure even in sub-zero weather. It uses less power when compared to conventional block heaters. Often, from one to two-thirds less!

Heating Pad installation is super simple- it does not invade any systems, nor does it require cutting any holes, welding, etc. Most installations are completed in less than an hour. Permanently mounts to the outside of a engine oil pan (or storage tank, hydraulic reservoir, transmission housing, gearbox, water tank, etc). Ideally, the heating pad is installed at the bottom of the fluid vessel to be heated because heat rises, however, the heating pad can also be installed on the side of the fluid vessel (below the level of the fluid).

A Wolverine Heater Pad will heat up and thin out your oil for quick starts in cold weather reducing wear and tear on the engine as well as most any other heating application you can think of.